This is not the first AUKEY product I own, but it’s the first one that I’m going to review. I can also tell you it’s not the last one either. I already own an AUKEY charger and it served me well for about 2 years now. There is no way I’m ever going to make a charger review sound exciting therefore I will keep it short, sweet and on point. Let’s dive in and see if AUKEY PA-S11 PowerHub is any good.
AUKEY PA-S11 PowerHub
The only important figures in mind are the power outputs. The AUKEY PA-S11 PowerHub comes with the following power specification:
- 16A fuse for mains pass through (wall sockets in the UK come with a 13A fuse by default)
- 4 x USB 2.4A each (6A total)
As you can see, the internal fuse is not likely to act as the standard wall socket would blow up its fuse first. The charger will throttle the current if all four ports are in use to about 1.5A each. You would be perfectly fine charging your phone, tablet and a smartwatch at the same time.
The USA version comes with two mains pass-throughs, so you can use 2 plugs and 4 USB-A ports at the same time.
I put the AUKEY PA-S11 PowerHub to the test and charged up my Google Pixel in the aeroplane mode from 10% battery to 100%:
- Pixel connected via USB-C using the original charger (benchmark) 1h:52min
- Pixel connected via USB-A using AUKEY charger 1h:45min
- Pixel connected via USB-A using AUKEY charger while two USB-A ports are in use 1h:53min
As you can see the AUKEY PA-S11 PowerHub is not a sloth and will deliver the charge quickly.
The critique
There is something I have to mention. The charger has been designed by people that aren’t familiar with the UK electrical layouts. In the UK older building often have the electrical sockets placed close to the floor. Should that be the case, you might find impossible to connect the charger or/and the USB cables due to lack of space.
I would also pay extra if the AUKEY PA-S11 PowerHub came with a WIFI enabled socket relay control (like the one from Oittm). The charger is bulky already and it would be an awesome addition to the USB charger and the pass-through design.
Conclusion
[tabs tab1=”Disclaimer”] [tab id=1]The AUKEY PA-S11 PowerHub has been provided to me for the purpose of the review. As usual, with all my reviews I reserve the right to an honest critique of the product.[/tab] [/tabs]I have no problems recommending this product providing your sockets are placed a fair distance from the floor. I will be using mine underneath my desk to add extra 4 USBs. Another possible use is to drive LEDs via USB sockets. With a little DIY, you could draw all 6A to power whatever LED strips you need by splicing 4 USB cables together.
I hope the AUKEY use my ideas to create a new version of the product with a WIFI relay control. I don’t believe I have seen one yet on the market.
You can get the charger using the links below: